Select a case

Pick the box the insert will live in.

W D H

Internal dimensions. These are parametric stand-ins until the measured case models land.

Add a tool

Pick one, then drag it onto the block to place it.

Silhouettes are drawn from the part's own geometry, so what you see here is what gets cut.

Cut it in

Drag the staged part where you want it, set clearance and depth on the right, then cut.

A pocket that overhangs the edge or touches its neighbour makes a model that will not print cleanly, so Cut this pocket stays disabled until the bar at the bottom of the screen is clear. Minimum wall 4 mm, minimum floor 3 mm.

—

100%

drag move · R rotate 15° · ⇧R back
arrows nudge 1 · ⇧arrows 0.1 · enter cut

Clearance 1.50 mm Finger notches on Min wall 4.0 · floor 3.0

Block Staged Contour

X—

Y—

ROT—

Z DEPTH—